Powering on the loggers

IP30 enclosure

To power on an Efento BLE logger in an IP30 enclosure, simply remove the battery-isolating foil that prevents the battery from making contact with the holder. The foil protrudes from the back of the device, so there is no need to open the enclosure.

If you ordered a logger with a calibration certificate, the battery-isolating foil was removed by the laboratory during the calibration process. This means the device is already powered on and operating.

IP67 enclosure

IP67 logger provide waterproof and dustproof protection. Because the enclosure is fully sealed, extra care is required when opening and closing the device to maintain its environmental rating.

1

Open the enclosure

Using a cruciform screwdriver (PZ1 / PH1), remove all screws from the enclosure.

2

Remove the battery-isolating foil

Take out the battery-isolating foil that prevents the battery from making contact with the holder.

3

Close the enclosure

Align the cover so the gasket sits evenly. Close the enclosure and reinstall all screws.

Ensure every screw is tightened securely -loose screws may allow water to enter the enclosure and damage the internal electronics.